Xtool M1 Benutzerhandbuch Seite 18

FCC statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(I) This device may not cause harmful interference,
This device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modifications not expressly
approved by the party responsible for compliance
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed
provide reasonable protection against harmfu
interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
equipment does cause harmful interference to radio or
television reception, which can be determined by turning
the equipment off and on, the user is encouraged
correct the interference by one or more of the following
(Hg)
o o
PCB
o o
o o
o
><
o o
x:
10
30
measures:
• Reorient or relocate the receiving antenna.
and (2) • Increase the separation between the equipment
• Connect the equipment into an outlet
different from that to which the receiver
• Consult the dealer or an experienced radio/TV technician
could for help.
FCC Radiation Exposure
to
This equipment complies with FCC radiation
limits set forth for an uncontrolled environment.
equipment should be installed and operated
minimum distance of 20 cm between the
your body.
If this
to try to
(PBB)
O o O
O o o
O o o
O o o
O o o
and
on a circuit
is connected.
Statement
exposure
This
with a
radiator and
(PBDE)
o
o
o
o
o