Timer Function; Radio Operation - Renkforce MT-35 Bedienungsanleitung

f) Timer function
• Press the VOLUME/POWER button (11) briefly to switch the device on. The STANDBY indicator (4) will go
off.
• You can now listen to music as described further down in this operating manual.
• To switch the device off after a defined period of time, press the TIMER/SLEEP button (8) repeatedly until
the desired time is set.
• The duration until switch-off can be set in 10 minute steps from 90 to 10 minutes. The device will switch
to standby after the set duration.
• The display will change to its normal operating display after a short time and SLEEP is shown in the
display if the timer function is activated.
• If you want to deactivate the timer function before the set switch-off duration, press the TIMER/SLEEP
button (8) repeatedly until SLEEP is no longer shown in the display.
g) Radio operation
Tuning
• Press the TUNER/BAND button (6) to select radio operation.
• Press the TUNER/BAND button (6) again to the select the desired reception range (AM = medium wave
or FM = VHF).
• Turn the TUNING/SKIP
start a channel scan in the selected direction. The tuner will stop at the next station that can be received
well.
• When turning the
changed by one step each time.
Saving stations manually
• As soon as a station was found, it can be saved to the station memory. To do this, press the MODE/CLK
button (14).
• Use the ALBUM/PRESET F button (19) or the ALBUM/PRESET S button (20) to set the desired station
memory and press the MODE/CLK button (14) again to complete the saving procedure.
• To save other stations, repeat the procedure described for each station to be saved. You can store as
many as 30 VHF stations and 20 MW stations.
• To call a station that is already saved, press the ALBUM/PRESET F button (19) or the ALBUM/PRESET S
button (20) repeatedly until the desired station memory is selected.
Saving stations automatically
Press the SCAN button (16).
• The reception range is searched and all stations that can be received well are saved to the station
memory successively.
• This procedure must be performed for the different bandwidths (MW and VHF) separately.
knob (23) to the right or left and keep it in this position for 1-2 seconds to
TUNING/SKIP knob (23) only briefly, the reception frequency will only be
41