To avoid distortion or mismatching which could damage the amplifier or the sub-
sequent component, only devices with cinch inputs may be connected to the cinch
outputs.
Connect the connection OUT (8) with the input of
the subsequent component.
Operation
Active Duplexer
Model XCA 400 and XCA 402
The amplifier is provided with an active duplexer which allows to switch a high-pass or a low-pass branch
for the rear channels. One high-pass branch is provided for the front channels.
The cut-off frequencies can be continuously adjusted.
Model XCA 200 und XCA 202
The amplifier is provided with an active duplexer which allows to switch a high-pass or low-pass branch
for the two channels.
The cut-off frequencies can be continuously adjusted.
The frequency duplexer switch X-OVER (4) sets
the operating mode of the active duplexer.
Cinch jacket (L)
> input left
Cinch jacket (R)
> input right
FULL:
Active duplexer switched off, the amplifier branch
plays back the complete frequency range
HPF:
High-pass duplexer switched on, the amplifier
branch only plays back the frequency range
above the frequency set via the HPF (1) control
unit.
LPF:
Low-pass duplexer switched on, the amplifier
branch only plays back the frequency range
below the frequency set via the LPF control unit
(2).
37