Herunterladen Diese Seite drucken

Arjo Sara Plus Active Slings Bedienungsanleitung Seite 11

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Apply the Walking and Standing Sling
In Chair/Wheelchair (24 steps)
(Only applies to sling KKA5130M)
For transfer/transport refer to Sara Plus IFU.
1. Place the Sara Plus lift nearby.
2. Apply the brakes on the wheelchair, if any.
3. Lean the patient forward and place the sling around
the lower back of the patient.
4. Make sure that:
the bottom edge of the sling is levelled with the
base of the spine (coccyx),
the sling attachment points are forward of the
body and have enough reach to attach to the
spreader bar,
the patients arms are outside of the sling,
the support belt is positioned loosely around the
patient's body,
the support belt is not twisted or trapped behind
the patient's back,
the support belt fits tightly but comfortable for
the patient,
each leg flap is placed under the patient's thigh
and connected with the support belts and
no pieces are twisted under the patient's legs
and back.
5. Fasten the support belt securely, by pressing the
hook and loop together. The strap should be tight,
but comfortable for the patient. (See Fig. 12 )
A
Fig. 10
Fig. 14
Fig. 11
Fig. 15
11
6. Pull the leg flap under the patient's legs.
(See Fig. 13 )
7. Only for patient's up to 190 kg (420 lbs): Connect
each leg buckle on the leg flap to the corresponding
body buckle. (See Fig. 14 )
8. Position the Sara Plus in front of the patient with
the front leg support just below the patient's knees.
Open up the chassis legs if needed. See the Sara
Plus IFU.
9. Apply the brakes on the Sara Plus.
10. Place the patient's feet on the Sara Plus foot
support.
11. Lower the Sara Plus Arc-Rest as low as possible,
allowing for obstructions e.g chair arms. See the
Sara Plus IFU.
For patient's up to 140 kg (308 lbs): Attach
each cord opposite from the patient, through
the sling attachment loops on the leg flaps
(See Fig. 15 )
For patient's up to 190 kg (420 lbs): Attach
each cord opposite from the patient, through
the sling attachment loops on the mid section.
(See Fig. 16 )
Continue with the steps on the next page
Fig. 12
Fig. 16
Fig. 13
EN

Werbung

loading