Operation; General Information - Conrad 77 69 43 Bedienungsanleitung

10. Operation

a) General information
• Place the film scanner on a level, firm, and sufficiently large area.
• If you want to use the included mains adapter for your power supply, connect the film scanner
to the power supply with the included USB able. Plug the power supply unit into a wall socket.
The power supply can also be connected through your computer's USB port. For this, use
a USB port of your computer or a USB hub with a separate mains adapter, since otherwise
the power supply will not suffice (e.g. in case of a USB port on the keyboard, etc.).
You may also use 4 type AAA/Micro batteries for power supply, see chapter 7).
• Switch on the film scanner (press the "
no memory card is inserted (or where the inserted memory card was not recognised), the
following image is displayed shortly before the main menu appears:

If no key is pressed for 30 minutes, the film scanner is automatically switched off
(power-save).
• Insert the slide or negative into the respective holder; see chapters 8 and 9.
Slide the holder into the film scanner from the right.
• The film scanner has an internal storage of 32 MByte, which, however, is not fully available
(part is required for internal purposes, e.g. interim storage of the scanned image, etc.).
As an alternative, a SD or MMC storage card can be used (not included in the delivery, must
be ordered separately). For this, the internal storage is switched off and the scanned images
are all stored on the storage card.
• For scanning, follow the information on the LC display integrated in the film scanner.
Function selection is performed with the arrow buttons; confirm with "ENTER".
32
" button). The welcoming screen appears.. Where