General Power Tool Safety Warnings; Work Area Safety - Parkside PBH 1500 D4 Originalbetriebsanleitung

Total vibration values (vector total of three
directions) determined in accordance with
EN 60745:
Main handle
Hammer drilling in
Concrete: a = 16.040 m/s², K = 1.5 m/s²
h(HD)
Additional handle
Hammer drilling in
Concrete: a
= 13.513 m/s², K = 1.5 m/s²
h(HD)
Main handle
Chiselling: a
= 12.765 m/s², K = 1.5 m/s²
h(CHeq)
Additional handle
Chiselling: a = 11.621 m/s², K = 1.5 m/s²
h(CHeq)
WARNING!
►The vibration level specified in these
instructions has been measured in
accableance with the standardised
measuring procedure specified in
EN 60745 and can be used to make
equipment comparisons. The declared
vibration total value may also be used in
a preliminary assessement of exposure.
The vibration level varies in accableance
with the use of the tool and may be
higher than the value specified in these
instructions in some cases. It is easy to
underestimate the vibration load if the
electrical power tool is used regularly in
this manner.
NOTE
►For an accurate estimate of the vibration
load during a certain working period,
the times during which the appliance
is switched off or is running but not
actually being used must also be taken
into consideration. This can significantly
reduce the vibration load over the total
working period.
PBH 1500 D4
General Power Tool
Safety Warnings
WARNING!
► Read all safety warnings
and all instructions.
Failure to follow the
warnings and instructions
may result in electric
shock, fire and/or serious
injury.
Save all warnings and
instructions for future
reference.
The term "power tool" in
the warnings refers to your
mains-operated (corded)
power tool or battery-
operated (cordless) power
tool.

1. Work area safety

a) Keep work area clean
and well lit. Cluttered
or dark areas invite
accidents.
b) Do not operate power
tools in explosive
atmospheres, such
GB
IE
NI
3