Parkside PDBNP 14 A1 Originalbetriebsanleitung Seite 45

♦ After installing the metal cone (E), check the distance between the
thread and metal cone (E). It should be approximately 70 mm. You
can use the assembly spanner
adapt the measurement by adjusting the lock nut (B).
B
approx. 70 mm
♦ To attach the front connector
feel minor resistance) and tighten it by hand.
♦ Tighten the front connector
│ GB │ MT
■ 42
as a measuring aid. If necessary,
E
, press it onto the thread (you will
using the assembly spanner .
PDBNP 14 A1