Herunterladen Inhalt Inhalt Diese Seite drucken

Tips And Tricks; Maintenance And Cleaning - Parkside PABS 12 B2 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für PABS 12 B2:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 62

Tips and tricks

Tip! This symbol indicates proper
behaviour.
Before operating the appliance, check whether
the screw or drill bit is correctly positioned, i.e.
centred in the drill chuck.
Screw bits are labelled according to their di-
mensions and their shape. If you are uncertain,
always check whether the bit fits tightly in the
screw head without any free play.
Torque:
Smaller screws/bits can be damaged if you set
the torque or rotational speed too high.
Hard screw joints (in metal):
Particularly high torques occur, for example, in
metal screw joints made using drive sockets.
Select a low rotational speed.
Soft screw joints (e.g. in soft wood):
Again, use a low rotational speed, to avoid
e.g. damaging the surface of the wood upon
contact with the screw head. Use a countersink.
When drilling in wood, metal and other
materials, observe the following:
Use a high speed for drill bits with small diameter
and a low speed for drill bits with large diameter.
Select a low speed for hard materials and a
high speed for soft materials.
Secure or fasten the workpiece in a clamp or
vice (if possible).
Mark the spot where you want to drill using a
centre punch or nail. Select a low rotational
speed when starting.
Pull the rotating drill bit from the hole repeatedly
to remove dust and chips and clear the hole.
8
 │ GB
Drilling in metal:
Use a metal drill (HSS). For optimum results,
cool the drill bit with cutting oil. Metal drill bits
can also be used to drill into plastics. Start with
a 3 mm diameter drill bit and then increase the
size until the desired hole diameter is achieved.
Drilling in wood:
Use a wood drill with a lathe centre; for deep
holes, use an auger bit; for large-diameter
holes, use a Forstner bit. Small screws can be
screwed directly into soft wood.

Maintenance and cleaning

WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
The cordless drill is maintenance-free.
The appliance must always be kept clean, dry
and free from oil or grease.
Never allow liquids to get into the appliance.
Use a soft, dry cloth to clean the housing.
Never use petrol, solvents or cleansers which
can damage plastic.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The optimum storage
environment is cool and dry.
NOTE
Replacement parts not listed (such as batteries,
switches) can be ordered via our service
hotline.
PABS 12 B2

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis