Yamaha DSP5D Bedienungsanleitung Seite 385

*1. Sensitivity is the lowest level that will produce an output of +4 dBu (1.23 V) or the nominal output level when the unit is set to maximum gain. (all faders
and level controls are maximum position.)
*2. XLR-3-31 type connectors are balanced. (1=GND, 2=HOT, 3=COLD)
* In these specifications, 0 dBu = 0.775 Vrms.
* All input AD converters are 24bit linear, 128 times (@48 kHz) oversampling.
* +48V DC (phantom power) is supplied to INPUT (1-48) XLR type connectors via one master and each individual software switches.
❏ Analog Output Characteristics (PM5D, PM5D-RH)
Output Actual Source
Terminals Impedance
STEREO A,B [L,R] 75Ω
MONITOR OUT
75Ω
[L,R,C]
CUE OUT [L,R] 75Ω
MATRIX OUT 1-8 75Ω
MIX OUT 1-24 75Ω
INSERT OUT 1-48 150Ω
PHONES (x 2) 15Ω
*1. XLR-3-32 type connectors are balanced. (1=GND, 2=HOT, 3=COLD)
*2. Phone jacks are balanced. (Tip=HOT, Ring=COLD, Sleeve=GND)
*3. PHONES stereo phone jacks are unbalanced. (Tip=LEFT, Ring=RIGHT, Sleeve=GND)
*4. There are switches inside the body to preset the maximum output level.
*5. INSERT OUTs are only provided for PM5D.
*6. The position of the level control is 10 dB lowered from Max.
* In these specifications, 0 dBu = 0.775 Vrms.
* All output DA converters are 24bit, 128 times (@48 kHz) oversampling.
❏ Analog Output Characteristics (DSP5D)
Actual Source
Output Terminals
Impedance
OMNI OUT 1-24 75Ω
*1. XLR-3-32 type connectors are balanced. (1=GND, 2=HOT, 3=COLD)
*2. There are switches inside the body to preset the maximum output level.
* In these specifications, 0 dBu = 0.775 Vrms.
* All output DA converters are 24bit, 128 times (@48 kHz) oversampling.
❏ Digital Input Characteristics (PM5D, PM5D-RH)
Terminal
1 AES/EBU
2TR IN DIGITAL
2 AES/EBU
3 COAXIAL
CASCADE IN
*1. XLR-3-31 type connectors are balanced. (1=GND, 2=HOT, 3=COLD)
❏ Digital Input Characteristics (DSP5D)
Terminal Format
*1
—
CASCADE IN
*2
—
CASCADE IN
*1. CASCADE (D-Sub 68pin) Max. Cable length: 200 m@48 kHz, 50 m@96 kHz
*2. CASCADE (RJ-45) Max. Cable length is based on EtherSound standard.
For Use With
*4
GAIN SW
Nominal
+24 dB (default)
600Ω Lines
+18 dB
+24 dB (default)
600Ω Lines
+18 dB
+24 dB (default)
600Ω Lines
+18 dB
+24 dB (default)
600Ω Lines
+18 dB
+24 dB (default)
600Ω Lines
+18 dB
10kΩ Lines —
8Ω Phones
—
40Ω Phones
For Use With
GAIN SW
Nominal
+24 dB
(default)
600Ω Lines
+18 dB
Format Data Length
AES/EBU 24bit
AES/EBU 24bit
IEC-60958 24bit
—
Data Length Level
— RS422
— 100Base-TX
PM5D/PM5D-RH V2 / DSP5D Bedienungsanleitung
Output Level
Nominal Max. Before Clip
+4 dBu (1.23 V) +24 dBu (12.28 V)
–2 dBu (616 mV) +18 dBu (6.16 V)
+4 dBu (1.23 V) +24 dBu (12.28 V)
–2 dBu (616 mV) +18 dBu (6.16 V)
+4 dBu (1.23 V) +24 dBu (12.28 V)
–2 dBu (616 mV) +18 dBu (6.16 V)
+4 dBu (1.23 V) +24 dBu (12.28 V)
–2 dBu (616 mV) +18 dBu (6.16 V)
+4 dBu (1.23 V) +24 dBu (12.28 V)
–2 dBu (616 mV) +18 dBu (6.16 V)
+4 dBu (1.23 V) +24 dBu (12.28 V)
*6
150 mW
75 mW
*6
150 mW
65 mW
Output Level
*2
Nominal Max. before clip
+4 dBu +24 dBu
(1.23 V) (12.28 V)
–2 dBu +18 dBu
(616 mV) (6.16 V)
Level
RS422
XLR-3-31 Type (Balanced)
RS422
XLR-3-31 Type (Balanced)
0.5Vpp/75Ω RCA Pin Jack
RS422 D-Sub Half Pitch Connector 68P (Female)
Connector
D-Sub Half Pitch Connector 68P (Female)
RJ-45
Connector
XLR-3-32 Type
*1
(Balanced)
XLR-3-32 Type
*1
(Balanced)
XLR-3-32 Type
*1
(Balanced)
XLR-3-32 Type
*1
(Balanced)
XLR-3-32 Type
*1
(Balanced)
Phone Jack (TRS)
*2 *5
(Balanced)
Stereo Phone Jack
*3
(TRS) (Unbalanced)
Connector
*1
XLR-3-32 type (Balanced)
Connector
*1
*1
385
Referenzteil