Herunterladen Inhalt Inhalt Diese Seite drucken

Mount The Collecting Bag For Sandblasting Material; Select And Fi Tting Attachments; Using The Compressed Air Sandblaster Gun; Collecting Bag For Sandblasting Material - Parkside PDSP 1000 B2 Originalbetriebsanleitung

Druckluft-sandstrahlpistole
Vorschau ausblenden Andere Handbücher für PDSP 1000 B2:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Mount the collecting bag for sand-
blasting material
Use a screwdriver to attach the collecting bag
to the appliance with the supplied screw
clip
.
Select and fi tting attachments
Start by selecting the appropriate attachment
for the job at hand ( ,
Push the selected attachment fi rmly onto the jet
nozzle
, ensuring that no air can escape from
the sides.
Using the compressed air sand-
blaster gun
Carefully prepare the workpiece that is to be
blasted. Clean it if need be.
NOTE
Layers of dust or fat will signifi cantly impair
the results.
Carefully cover or mask everything that is not to
be blasted.
The distance between the attachment and the
surface being worked plays an important role
and should be kept as low as possible so that
the blasting medium
collecting
.
The nearer you are to the workpiece, the smaller
the dispersion pattern and vice versa.
Do a test run on an old workpiece to fi nd out
the correct distance/working pressure and avoid
excessive refl ection from your workpiece.
Switching on:
Set the control dial
outlet.
Move the compressed air sandblaster
to the area to be worked.
Press the trigger
to start operating the com-
pressed air sandblaster gun
Switching off :
Release the trigger
pressed air sandblaster gun
Set the control dial
outlet.
PDSP 1000 B2
).
,
,
can be collected by the
to "1" to open the air
close
.
to switch off of the com-
.
to "0" to close the air
Disconnect the appliance from the compressed
air source after you fi nish work.
NOTE
First detach the hose from the compressed air
source before disconnecting the supply hose
from the appliance.
In this way you avoid uncontrollable thrashing
about of the supply hose.
Collecting bag for sandblasting
material
NOTE
Do not re-use surplus sand-blasting material
from the collecting bag
cleaned.
You can remove the surplus sand-blasting material
that has collected in the collecting bag
the zip fastener or use a screwdriver to undo
the screw clamp
bag
from the appliance.
until it has been
via
and remove the collecting
GB
21

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ian 43089

Inhaltsverzeichnis