Connecting The Cord; Wall Mounting The Speaker For Bcs - Pioneer XV-BD422B Bedienungsanleitung

22 Connecting
En
5 Fix the upper cabinet and the lower cabinet
from the backside of the speaker using the
two screws (M4 x 12).
2
Caution
• Be careful not to tighten screws excessively.
If excessive force is used to tighten screws, the
threads of screw and/or nut may be damaged. Use
a middle-sized manual screwdriver during assembly.
Do not use power screwdrivers or oversized
screwdrivers that may exert excessive force on the
screws and nuts. Confirm that no foreign matter
is stuck to the base or the lower cabinet during
assembly. If the unit is assembled with foreign matter
stuck between the base and lower cabinet, the unit
may not be assembled securely, resulting in tipping
or falling.
• Do not stand on the speaker stand base of the tall
speaker to push or swing the speaker. The speaker
may fall and break, or someone may be injured.
Pay special attention to children.

Connecting the cord

1. Attach one end of the supplied speaker
cord to the rear of the each speaker.
Connect the wire with the colored marker
to the red (+) terminal; the plain wire to the
black (−) terminal. Press down the spring-
loaded tab and insert the wire, as shown
below. Release the tab to secure the wire.
Red (+)
Black (–)
Red colored marker
Wall mounting the speaker for
BCS-424
The center speaker have a mounting hole
which can be used to mount the speaker on
the wall.
Before mounting
Remember that the speaker system is heavy
and that its weight could cause the screws
to work loose, or the wall material to fail to
support it, resulting in the speaker falling.
Make sure that the wall you intend to mount
the speakers on is strong enough to support
them. Do not mount on plywood or soft surface
walls.
Mounting screws are not supplied. Use screws
suitable for the wall material and support the
weight of the speaker.
Caution
• If you are unsure of the qualities and strength of
the wall, consult a professional for advice.
• Pioneer is not responsible for any accidents or
damage that result from improper installation.
5 mm
10 mm
Mounting screw
(not supplied)
5 mm to 7 mm