Machine Transport/Parking - Nilfisk SC3519087340020 Betriebsanleitung

NOTE
For correct scrubbing/drying of floors at the sides of the walls, Nilfisk suggests to go near the walls with the right side of
the machine as shown in figure 2.
Machine speed adjustment
5. The machine speed varies according to the type of floor to be cleaned and the choice of using the brush or the pad. If
necessary, it is possible to adjust the machine speed, according to the procedure shown in Maintenance chapter.
Battery discharge during operation
6. Until the green warning light (37) stays on, the batteries allow the machine to work normally. When the green warning light
turns off and the yellow and red warning lights turn on, it is necessary to charge the battery as the machine residual autonomy
is at the minimum level.
CAUTION!
Do not use the machine with discharged battery, to avoid damaging the battery and reducing the battery life.

MACHINE TRANSPORT/PARKING

To transport/park the machine, proceed as follows.
1. Check that the function selection knob (31) is turned to "0".
2. Grab the handlebar (2) and slightly lift the machine brush deck. While holding the machine in this position, drive it to the
transport/parking area.
3. When finishing working, it is advisable to remove the brush/pad in order not to drag it on the floor and leave wet marks.
A
USER MANUAL
Figure 2
9099864000 - SC351
B
ENGLISH
P1004108
13