Motor Unit With Multifunction Tool Pkga4 - Parkside PKGA 14.4 A1 Originalbetriebsanleitung

2. To unlock, release the lever (19),
it will return to the initial position.
3. Check that the sawblade is se-
cure by pulling on it.
Removing the sawblade:
4. Press the lever (19) for sawblade
unlocking upwards as far as the
stop and then pull the sawblade
out of the sawblade mounting.
For certain work, the sawblade
can also be inserted after turning
through 180°.
Operating the sabre saw
1. Before switching the appliance on,
ensure it is not in contact with the work-
piece.
2. Turn the appliance on.
By using the on/off switch (
can progressively control the stroke
rate.
Gentle pressure: low stroke rate.
Greater pressure: higher stroke rate.
The on/off switch cannot be locked.
3. Place the footplate (
piece.
4. Cut with a uniform forward motion.
5. After completion of the work, first re-
move the blade from the saw cut and
then switch the appliance off.
Motor unit with multifunction
tool PKGA4
Changing the tool
Secure the appliance against
switching on (see "Switch-
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
11) you
18) on the work-
1. Push the lever (27) for tool un-
locking upwards as far as the
stop.
2. Pull the unlocked tool holder (29)
off forwards.
3. Place the required tool
(30/32/33) on the arbor (28).
12 different positions are pos-
sible.
4. Press the tool holder (29) back
into the central mounting.
5. Push the lever (27) for tool un-
locking forwards again. The tool
holder is fixed to the tool.
Attaching/removing sanding
sheet
The delta sanding plate (30) is fitted with
Velcro for rapid attachment of the sanding
sheet.
Attaching sanding sheet
1. Press the sanding sheet (31)
evenly onto the delta sanding
plate (30). Ensure that the holes
in the sanding sheet are placed
above the openings in the sand-
ing plate.
Removing sanding sheet
2. Simply pull the sanding sheet
(31) off the delta sanding plate
(30).
GB IE
17