Technical Data; General Safety Advice For Electrical Power Tools; Workplace Safety - Parkside PAR 10.8 B1 Montage-, Bedienungs- Und Sicherheitshinweise

Technical Data

Cordless ratchet:
Rated power:
Idling speed:
Max. torque:
Square drive:
Rechargeable battery: PAR 10.8 B1-1
Type:
Rated voltage:
Capacity:
Battery rapid charger: PAR 10.8 B1-2
Input:
Rated voltage:
Power input:
Output:
Rated voltage:
Charging current:
Charging time:
Fuse (internal):
Protection class:
Noise and vibration data:
Values for noise determined in accordance with
EN 60745. The A-rated noise level of the power
tool is typically:
Sound pressure level:
Sound power level:
Uncertainty K:
Vibration (vector sum in three directions) determined
according to EN 60745:
Drilling: vibration emission value a
Uncertainty K = 1.5 m / s
Wear ear protection!
Note: The vibration level specified in these instruc-
tions was measured in accordance with an EN 60745
standardised measurement process and can be used
to compare tools. The vibration emission value spec-
ified can also serve as a preliminary assessment of
the exposure.
Introduction / General safety advice for electrical power tools
PAR 10.8 B1
10.8 V (split into 3 recharge-
able battery cells)
n 220 min
-1
0
45 Nm
LITHIUM-ION
10.8 V
1.5 Ah
200–240 VAC, 50–60 Hz
32 W
12.6 VDC
1.8 A
approx. 60 min
2 A T2A
II /
78.2 dB(A)
89.2 dB(A)
3 dB
= 2.390 m / s
h
2
emit different vibration levels and in some cases these
may exceed the values specified in these instructions.
It is easy to underestimate the vibration load if the
power tool is used regularly in particular circum-
stances. Try to keep the vibration loads as low as
possible. Measures to reduce the vibration load are,
e.g. wearing gloves and limiting the working time.
All states of operation must be included (times when
the power tool is switched off and times where the
power tool is switched on but running without load).
General safety advice for
electrical power tools
and instructions! Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
Keep all the safety advice and instructions
in a safe place for future reference!
The term "electrical tool" used in the safety advice
refers to electrical tools powered by mains electricity
(by means of a mains lead) and electrical tools pow-
ered by rechargeable batteries (without a mains lead).

1. Workplace safety

a) Keep your working area clean and well
lit. Untidy or poorly lit working areas can lead
to accidents.
b) Do not work with the device in poten-
2
tially explosive environments in which
there are inflammable liquids, gases or
dusts. Electrical power tools create sparks,
which can ignite dusts or fumes.
c) Keep children and other people away
while you are operating the electrical
tool. Distractions can cause you to lose con-
trol of the device.
Different power tool uses will
Read all the safety advice
GB/IE 7