Control / Operation; Starting And Operating The Machine; Auto-On / Off Socket Outlet For Power Tools - MIRKA 1230 L Bedienungsanleitung

en
[original instruction]

3. Control / Operation

CAUTION
Damage due to unsuitable mains voltage . The appliance can be damaged as a result of being connected to an
unsuitable mains voltage .
• Ensure that the voltage shown on the rating plate corresponds to the voltage of the local mains power supply .

3.1 Starting and operating the machine

Check that the electrical switch is switched off (in position 0) . Check that suitable filters are installed in the machine .
Then connect the suction hose into the suction inlet on the machine by pushing the hose forward until it fits firmly
into the inlet . When used for dust extraction together with a dust-producing tool, connect the end of the suction hose
using an appropriate adapter . Connect the plug into a proper electrical outlet . Put the electrical switch into position I in
order to start the motor .

3.2 Auto-On / Off socket outlet for power tools

CAUTION
Appliance socket
The appliance socket is designed for electrical auxiliary equipment; see technical data for reference .
• Prior to plugging in an appliance, always switch off the machine and the appliance that is to be connected .
• Read the operating instructions for the appliance to be connected and observe the safety notes contained in these .
An earthed appliance socket is integrated in the machine . An external power tool can be connected there . The
socket features permanent power on when the switch is set to the
extension cord . Australia: The socket has a 5 Amp thermal fuse to protect the machine against overload . If the power
consumption gets too high the thermal fuse activates and cut off the power on the socket outlet . The thermal fuse can
be deactivated again by pressing the knob .
In position , the machine can be switched on and off from the connected power tool .
Dirt is picked up from the source of dust immediately . To comply with regulations, only approved dust-producing tools
should be connected .
The maximum power consumption of the connected electrical appliance is stated in the "Specifications" section .
Before turning the switch to position
3.3 Push & Clean
The "PC" machine is equipped with a semiautomatic filter cleaning system, Push & Clean . The filter cleaning system
must be actuated when the suction performance starts to fade . Regular use of the filter cleaning feature maintains
suction performance and increases the lifetime of the filter . For instructions, see the quick reference guide .
80
Mirka® Dust Extractor • 1230 L • 230 V • PC & AFC
Turn to I: Activate the dust extractor .
Turn clockwise for speed control .
Turn to 0: Stop the dust extractor .
Turn to sander: Activate Auto-On/Off .
Operation – turn counter-clockwise for speed control .
Turn to I: Activate the dust extractor .
Turn to : Stop the dust extractor . Permanent power on socket .
Turn to I: Activate Auto-On/Off operation .
Turn to I + AFC Off: Activate the dust extractor with deactivated Auto Filter Cleaning .
Turn to sander + Off: Activate Auto-On/Off operation with deactivated Auto Filter Cleaning .
Speed control operation on separate rotary knob .
, ensure that the tool connected to the appliance socket is switched off .
position, i .e . the machine can be used as an