Seltron ST+ Betriebsanleitung Seite 5

Place of mount
Place of mount is very important for proper ST operation. Suitable places are inner walls, which aren't
sun lighted or exposed to sources of heat and wind. ST should be mounted approximately 150 cm above
the floor.
Wall plate mount
Remove the ST from the wall plate, by doing the
following. With one hand hold ST in height of
keys and with other hand the wall plate. Now pull
them apart.
Unscrew and temporarily remove the protection
cover (Picture a). Room thermostat is intended for
wall mounting. In case you don't have installed a
flush box, tear away the drilling template from the
package and mark drilling holes. Bring the wires
through the opening in bottom of the wall plate
(Picture b-position A) and se enclosed screws to
fasten the wall plate on the wall (Picture b). After
you have done connecting the wires, screw back
the protection cover. Now put ST back onto the
base by doing the following. Hook ST on top of
the wall plate and push it with bottom towards the
wall plate.
For the
flushbox
Screws
For the
wall
Picture a
5
Picture b
Installation manual