Using The Device; A) Installation/Setup - Renkforce 1386535 Bedienungsanleitung

6. Using the device

To ensure that the device is set up correctly, do not fail to read through these operating instruc-
tions including the safety instructions thoroughly and attentively before use.
Check the device for damage before using it for the first time. If the device is damaged, do not
operate it and consult an expert or our service team.

a) Installation/Setup

The assembly and the installation of the device must be carried out by a specialist who is fa-
miliar with the hazards and the relevant regulations. Repairs, operation and maintenance may
only be carried out by qualified personnel.
When choosing a location for your device, make sure to avoid vibration, dust, hot and cold tem-
peratures and dampness. Furthermore, no powerful transformers or motors must be set up close
to the device.
When installing/setting up the device, make sure that neither the power cable nor the remote
control cable is squashed or damaged by any sharp edges.
Do not use the device on flammable surfaces or in the proximity of flammable objects. Maintain
a distance of at least 0.5 m to flammable objects.
Make sure that the fog outlet is not directed towards persons, animals or open fires. The
discharged hot vapour can cause burns (keep a safety distance of 0.5 m).
To ensure sufficient ventilation, keep a minimum distance of approx. 20 cm to other objects
around the device and do not cover the ventilation openings.
Always place the device on a stable surface. If it falls down, people might be injured.
The device must be operated in a horizontal position (max. tilt: 15°) so that the tank does not lose
fluid when it is filled or operated.
The device must be installed/set up out of normal reach. If the fog machine is installed on a wall
or in an elevated position, the area below the machine must not be entered (slippery surface,
risk of injury due to hot fog fluid and its residues).
During installation or service work, the area below the place of installation must be cordoned
off.
The installation surface and the installation material must be designed to support ten times the
rated load for at least one hour without suffering permanent and harmful deformation.
In addition, the device must be secured with a second independent safety fixture besides the
actual installation material when installed with the installation bracket. If the main support
fails, no part of the installation must fall down.
Install the device according to the applicable legal requirements.
19